Shop Lumber & Hardware
Resources

November 19, 2026

Custom Pole Barns for Nashville, Clarksville & Columbia, TN

The PAC Blog > Article

< back

November 19, 2026

Quick answer: PAC Building Pro designs and builds custom post-frame pole barns on your property throughout Middle Tennessee, including Humphreys County, Waverly, and out to Nashville, Clarksville, Columbia, and Jackson. Pole barns are built to order with financing available; they're constructed on-site and engineered for local snow and wind loads, with PE-stamped plans provided when your county requires them.

When you need more covered space than a carport can handle—room for tractors, hay storage, a full workshop, or multiple vehicles—a custom pole barn gives you the square footage and flexibility to build exactly what your property needs.

PAC Building Pro has been serving Waverly, Humphreys County, and Middle Tennessee for years, and we've learned that every pole barn project starts with the same questions: What size do I need? What will it cost? Do I need a permit? Do I need engineered plans? Let's walk through the answers so you can plan with confidence.

What is a pole barn, and how is it built?

A pole barn—also called a post-frame building—uses vertical posts (typically pressure-treated wood) set in concrete or directly in the ground to carry the roof load, instead of a traditional stud-frame foundation and wall system. Engineered wood or steel trusses span the posts, and metal roofing and siding (usually 29-gauge or 26-gauge steel) enclose the structure.

Pole barns go up faster than stick-built buildings, and the post spacing creates wide-open interior space with no load-bearing walls. That makes them ideal for equipment storage, livestock shelters, workshops, and hay barns across rural Middle Tennessee.

Local note: In unincorporated Humphreys County, no building permit is required for pole barns. Inside Waverly, New Johnsonville, or McEwen city limits, you'll need a city permit. A county site close to city limits may also need a separately purchased zoning permit. Rules vary by county and city across Middle Tennessee, so always check with your local codes office before you start.
Pole Barns by PAC Building Pro in Middle Tennessee
A PAC Building Pro build in Middle Tennessee

What sizes are most common for pole barns in Middle Tennessee?

Pole barn size depends on what you're storing and how much room you need to move equipment in and out. Here are the sizes we build most often and what typically fits inside:

Size Square Feet Common Uses
30×40 1,200 Multiple vehicles, small tractors, workshop with storage
40×60 2,400 Large tractors, RVs, commercial equipment, hay storage
40×80 or larger 3,200+ Multiple bays, livestock shelter, full shop with office

Every pole barn we build is custom, so if you need a different size, different door placement, or a specific roof pitch, we design it to fit your property and use.

Thinking about a pole barn or shop?
Get a free, no-pressure quote at pacbuildingpro.com or call (931) 296-2777.

How much does a custom pole barn cost in 2026?

Cost depends on size, how you finish it, and what your site requires. A bare-bones shell—posts, trusses, roof, and siding with minimal doors—costs far less than a fully finished building with concrete floor, insulation, wiring, and multiple overhead doors.

Here's what moves the price up or down:

  • Building size: Square footage is the biggest cost driver.
  • Roof pitch and complexity: Steeper roofs and complex designs require more material and labor.
  • Doors: Overhead doors cost more than sliding or walk-through doors; the number and size matter.
  • Concrete slab: Pouring a floor adds significant cost but makes the building far more useful.
  • Insulation and interior finish: Insulating walls and ceiling, adding wiring, or finishing interior walls increases cost.
  • Site preparation: Grading, drainage, and access affect the cost of getting the building ready to construct.
  • Engineered plans and permits: If your county requires PE-stamped plans or a building permit, factor in the added cost and lead time.

We provide a detailed written quote for every project, so you know exactly what you're getting and what it costs before we start. Financing is available for custom pole barns.

Do I need engineered plans or a building permit?

This is the question that confuses buyers most, because the answer changes depending on where you live in Middle Tennessee.

Engineered plans: PAC provides building drawings engineered for the local snow and wind loads in Middle Tennessee. These drawings specify post embedment, truss spacing, load ratings, and attachment methods to meet local requirements.

Engineer-stamped plans (signed and sealed by a licensed professional engineer) are not always required. Whether you need a PE stamp depends entirely on your county or city codes department and whether your site is inside city limits. Many rural Middle Tennessee counties—including Humphreys County—do not require stamped plans for agricultural or personal-use pole barns. Some cities and counties do require them. PAC can provide PE-stamped plans on request when your jurisdiction requires them; there is an added cost and lead time.

Good to know: Tennessee Code § 13-7-114 exempts buildings on agricultural land that are incidental to the agricultural enterprise from county building permit requirements, except near state highways, airports, or parks. This exemption applies to counties only, not municipalities, and you may need to provide proof of agricultural use.

Building permits: Permit requirements vary widely. In unincorporated Humphreys County, no building permit is required. Inside Waverly, New Johnsonville, or McEwen city limits, a city permit is required. A county site close to city limits may also need a separately purchased zoning permit. Every other county and city in our service area has its own rules—some enforce state codes, some adopt their own, and some rural counties have opted out of building codes entirely.

Before you start any pole barn project in Dickson, Benton, Perry, Hickman, Houston, Henry, Maury, or any other Middle Tennessee county, contact your local building or codes department to confirm what's required. The permit (if needed) is the customer's responsibility, and we're happy to help you understand what your jurisdiction asks for.

Where does PAC Building Pro serve?

We're based in Waverly, the county seat of Humphreys County, and we build custom pole barns throughout Middle Tennessee—roughly a 70-mile radius from our shop.

We serve Humphreys County (Waverly, New Johnsonville, McEwen, Hurricane Mills) and the surrounding counties where PAC is the closest builder: Houston County (Erin, Tennessee Ridge), Benton County (Camden, Big Sandy), Perry County (Linden, Lobelville), Hickman County (Centerville), Dickson County (Dickson, White Bluff, Burns, Charlotte), and Henry County (Paris, Puryear, Springville).

We also build and deliver to Nashville (Davidson County), Clarksville (Montgomery County), Columbia and Spring Hill (Maury County), Jackson (Madison County), and other counties including Stewart, Robertson, Cheatham, Williamson, Lewis, Wayne, Lawrence, Decatur, Henderson, Carroll, Weakley, and Hardin. For those farther-out areas, we compete on custom design, delivery capability, and honest pricing—not as your in-town builder, but as a family-run shop willing to make the drive.

We deliver prefab building packages (portable buildings, steel carports, prefab metal garages) to nearby western Kentucky—Murray, Cadiz, Hopkinsville—but PAC does not build or install pole barns on-site in Kentucky. Kentucky deliveries are prefab products only.

What about inspections and setbacks?

Inspection schedules (footing, framing, final) and setback distances from property lines are set by local zoning ordinances. Some jurisdictions require inspections at multiple stages; others have no inspection requirement at all. Setback rules—how far the building must sit from your property line—also vary by county and city.

Always confirm local zoning and setback rules with your county or city office before you decide where to place the building. Correcting a setback violation after construction is expensive and frustrating.

How long does it take to build a pole barn?

Lead time depends on the complexity of the project, the weather, and how busy our schedule is. A straightforward pole barn on a level, prepped site goes up faster than a complex build on sloped or difficult ground.

When you request a quote, we'll give you an honest timeline for design, permitting (if required), and construction. Custom pole barns take longer than delivered prefab buildings, but the result is a building designed exactly for your property and use.

Frequently Asked Questions

Do I need a concrete floor in my pole barn?

A concrete slab isn't required, but it makes the building far more useful if you're parking vehicles, running equipment, or setting up a workshop. Gravel or dirt floors work fine for hay storage or livestock shelter. We can price your pole barn with or without concrete so you can decide what fits your budget.

Can I finance a custom pole barn?

Yes. PAC offers financing for custom pole barns. Pole barns are not rent-to-own or no-credit-check; those options apply only to our delivered prefab buildings like portable sheds and carports. Contact us for financing details and to get a quote.

What's the difference between a pole barn and a stud-frame building?

A pole barn uses vertical posts set in the ground or concrete to carry the roof load, creating open interior space with no load-bearing walls. A stud-frame (stick-built) building uses a traditional foundation and wall framing. PAC builds both, and we can help you choose the method that best fits your site, budget, and how you plan to use the building.

Does PAC build pole barns in Clarksville or Nashville?

Yes. We build custom pole barns in Clarksville (Montgomery County), Nashville (Davidson County), and throughout Middle Tennessee within roughly 70 miles of Waverly. For those farther-out areas, we compete on custom work, delivery capability, and price. Call (931) 296-2777 or visit our website for a free quote.

Ready to plan your custom pole barn? Whether you're in Waverly, Humphreys County, Dickson, Columbia, Nashville, or anywhere in Middle Tennessee, PAC Building Pro will work with you to design a building that fits your property, your budget, and your plans. Get a free quote at pacbuildingpro.com or call us at (931) 296-2777. We're here to help.

Keep reading

More on this from the people who build them in Waverly.